Preparation

Glass film method

01 Glass Film-Preparation

Before applying film to the glass, check the film first. If there is no problem, you can measure the size of the glass first, and then cut the glass film according to this data to avoid errors when applying it.

When applying glass film, do not tear off the adhesive paper too much directly. Tear it off a little first. It is best to start from a corner, and then align this corner with the corresponding position on the glass. Then slowly tear off the adhesive paper a little bit and gradually stick it to the glass. During the whole process, you do not need to pay attention to whether there is any offset. If there is offset, you need to correct it in time.

02 Glass Film-Cleaning

Before applying film on the window glass, you need to clean the glass thoroughly, then spray more water on it, and scrape it several times with a scraper until the glass is free of hair and shines brightly.

03 Glass Film-Water Spray

You need to spray some water on the glass. After cleaning the glass, spray another layer of water to ensure better paving and increase the tightness between them.

04 Glass Film-Separate

When sticking the film, you should also spray some water on it. The main purpose is to separate the two layers of film, and then spray some water on the adhesive surface of the film.

05 Glass film-scrape flat

When applying the film, scrape off the water between the film and the glass. Be careful to scrape the water out slowly. Finally, cut off the excess parts of the film corners. If there are bubbles or raised areas, press them hard.

Summary of glass film application skills

1. When cutting the film, the film should be more than 1 cm longer than the glass. This can avoid unexpected situations when applying the film, and can be adjusted in time, and can also avoid affecting the installation effect due to measurement errors.
2. The film is generally divided into two layers, one is a colorless transparent protective film, and the other is a colored film. Don't make a mistake and pay attention to their corresponding positions.

3. When applying the protective film, you need to scrape off the moisture in four directions so that there will be no bubbles on the film and the overall decoration style can be improved.

4. The overall process of film pasting is relatively simple. You need to pay attention to the accuracy of the measurement data, the alignment of the installation position, and the leveling of the scraping. This can improve the overall effect of the window glass film.